Available. 4 open slots. The M7i and M10i routers are the choice for consolidating multiple services onto a single IP/MPLS Number of PIC Slots. Part Number: M10IBASE. The command output for an M10i router. 8 open slots. Four PIC slots are located in each Flexible PIC Concentrator (FPC). The PIC slots on the upper FPC are numbered from 0/0 (zero/zero) through. In these systems, the PIC slot numbering goes from right. M10IBASE-DC Juniper M10i Base Unit 8 Pic Slot Chassis Cooling Midplane 2 Dc Power Supplies 1 Forwarding Engine 1 Routin (Refurbished) ; Was: $ ; Part #. . To check PIC status including port information, use the show chassis pic pic-slot # fpc-slot # command. PIC slot numbering in horizontally aligned systems such as the M7i and M10i is a little less standard. Does it mean that there is Mbps limitation on each PIC inserted in PIC slot on given FPC? Or is it an. slot 3 is used for the fixed Ethernet interfaces. M10IBASE-DC Juniper M10i Base Unit 8 Pic Slot Chassis Cooling Midplane 2 Dc Power Supplies 1 Forwarding Engine 1 Routin (Refurbished). This article describes what can happen when a PIC is improperly inserted into a slot on the M10i device: the neighboring PIC can malfunction. of Gbps per FPC on m10i routers. Figure PIC slot numbers for M7i, M10i, and M20 Figure M7i PIC slot numbering In the SRX and MX.